Fence Company in Fresno, CA | Wood, Vinyl & Gate Installation

Fence Company in Fresno, CA: Installation, Repair & Gates

Homeowners searching for a fence company near me in Fresno turn to Fresno Fence Company for the full range of fencing and gate work. We install new wood and vinyl privacy fences, chain link, and aluminum and ornamental iron fencing on the lots that make up the neighborhoods of Fresno, Old Fig Garden, Clovis, Sunnyside, and Sanger. We repair leaning and damaged fences, replace failed posts, install and repair gates including automatic driveway gates, handle pool barrier fencing, and restore fences that have weathered. We also respond to winter storm damage and work with commercial and farm operations on temporary and permanent fence lines.

This is a local operation. The same crews do the work, they know the clay soil and the winter wet that works a post loose, and they are not dispatched from a call center. When you call (559) 795-3955 for a free estimate, you reach people who can walk your fence line and tell you honestly whether repair will hold or replacement is the better spend.

Why Fences Lean in Fresno: Clay Soil and Rotted Posts

Most leaning fences in this area are a post problem, not a panel problem. The clay soil here swells when saturated in winter and shrinks as it dries through the spring and summer. That seasonal movement works a post back and forth in its footing year after year, gradually racking it out of plumb. At the same time, moisture collects at the ground line where the post sits in soil and concrete, and wood decays there from the inside out. A fence that looked straight in June may lean noticeably by March after a wet winter, and the lean does not correct itself when the soil dries again.

We read a fence line by walking the whole run and testing every post, not just the section that prompted the call. We check whether posts are loose in sound footings or whether the concrete itself has heaved, and we look at the wood at ground level to see whether it is still solid or has rotted through. This tells us what we are actually working with. A fence with sound pickets and rails and a handful of failed posts is worth repairing. Resetting those posts or replacing them in fresh concrete saves the rest of the fence and costs far less than tearing the whole thing down. A fence where the posts have decayed at the ground line along the whole run has reached end of life, and repairing it section by section costs more over five years than replacing it once. We quote both options when both are real, so you can make the choice that fits your budget and timeline.

When we replace wood, we replace wood that has decayed from moisture at the ground line. We do not perform termite or pest inspections, apply chemical treatments, or carry out pest control, that is a separate regulated trade in California. If you want to discuss what you have found or what concerns you about the fence, call (559) 795-3955 or request a free estimate. We can walk the line with you and explain what we see.

Storm Damage Fence Repair in Fresno

Winter storms push fences over on the same line, snap posts at grade, and tear panels away. A fence that survives a storm by chance is not a fence that should be rebuilt as it was. When we rebuild after wind damage, we set posts deeper and in fresh concrete, and we use post spacing and bracing that better resists the wind loads this region sees. The work costs more than a patch, but it lasts.

We provide a free damage assessment and photograph your fence section by section. We write a detailed estimate that you may give to your insurance carrier if you choose to file a claim. We help you document what happened and what repair costs. Coverage decisions rest with your carrier, and the timing and terms of any payout are theirs to set. We do not act as an adjuster, do not represent you in claim negotiations, and do not waive, absorb, or discount any deductible. What we do is give you honest numbers to work from. If you have storm damage, call us for a Storm Damage Fence Repair assessment.

Cedar, Pine, Vinyl or Chain Link: Choosing for This Climate

Cedar looks beautiful and weathers to a soft gray if left untreated, but it demands maintenance. Under this sun and humidity a cedar fence wants cleaning and re-staining every two to three years, and that cycle is what decides whether it lasts closer to ten years or closer to twenty. Pressure-treated pine is a smarter budget call for most homeowners here. It is not as pretty out of the box, but it holds up through the wet winters and hot summers without the same upkeep, and it costs less to start with. Vinyl and PVC fencing eliminate the staining cycle entirely and resist fading and moisture, though they are stiffer to work with on sloped lots and cost more per linear foot. Chain link is the toughest value per dollar and comes in galvanized steel (silver, low maintenance) or black powder-coated (darker, slightly better corrosion resistance). The gauge of the wire and the mesh size matter for longevity and appearance. Aluminum and ornamental iron fences suit front yards, pool barriers, and slopes where racking the panels to follow grade makes sense.

Every fence is quoted by the linear foot and priced on site, because slope, soil conditions, access for removal, and gate count change the actual work. Request a free estimate and we will walk your property and explain the trade-offs for your situation. See our Wood & Privacy Fence Installation and Vinyl & PVC Fence Installation pages for more detail on those materials.

Permits, HOA Rules, Property Lines & Pool Barriers

Fence height, setback, and material rules are set by the city or county and vary across the Greater Fresno area. In most jurisdictions a permit is required before a fence is installed, though the threshold and process differ. Many cities in the area also require corner-visibility clearances and material approval. If you live in a master-planned community or a neighborhood with an HOA, deed restrictions and architectural standards commonly govern fence height, material, and color, and approval is usually needed before work starts. It is worth checking with your HOA or reviewing your deed restrictions before you design your fence. Setting posts is excavation, and California law requires that we request a utility locate through California 811 before digging. Locates cover participating utility operators only and do not mark private lines such as irrigation or landscape lighting, so tell us if you have those on your property.

Pool barrier fencing is installed to meet the local pool barrier codes that apply at your address, with self-closing self-latching hardware on any gate. The local building official determines final compliance, and we do not certify that a barrier meets code, that determination is theirs alone. No barrier replaces supervision of children in or near water. On property lines, we install on the line you identify, working from your existing survey or plat. Determining a boundary is the work of a licensed land surveyor, and it is worth confirming your line and any neighbor or HOA consent in writing before we start. Requirements vary, always verify with the Fresno building department and your HOA before starting your project. Call (559) 795-3955 or contact us for a free estimate and we can discuss what applies to your address.